Digitrax Zephyr - DCS50 Option Switch Configuration Table; Table of DCS50 Option Switch Effects and Factory Settings

DCS50 Option Switch Table
Option
Switch #
Effect on System operation when "closed"
Factory
Setting
OpSw 01
c=1 Jump Port t=2 Jump Ports
t
OpSw 02
c=DCS50 runs as booster/throttle with no
command station capability
t
OpSw 03
c=DCS50's booster is auto reversing
t
OpSw 05
c=No change allowed for Throttle ID, Vmax
or Brake Rate
t
OpSw 06
c=Function 3 is non-latching
t
OpSw 13
c=Loco address purge time extended from 200
seconds to 600 seconds
t
OpSw 14
c=Loco address purging is disabled
t
OpSw 15
c=Purging will force a loco to Stop or 0 speed
t
OpSw 17
c=Automatic advanced decoder assisted
consists are disabled
t
OpSw 18
c=Extend the DCS50 booster short circuit
shutdown time from 1/8th to 1/2 second
t
OpSw 20
c=Disable address 00 or analog stretching for
conventional locomotives.
t
OpSw21
c=OPSW21-23 set the global system default
type for "NEW" loco selections.
t
OpSw 22
SW21/22/23 set as follows:
t-t-t=3 128 step mode
t-t-c=7 128 step FX mode
t
OpSw 23
c-t-t=2 14 step mode
c-c-t=0 28 step
t-c-c=5
t
OpSw 27
c=Disable normal switch commands, a.k.a. the
"Bushby bit." Allows attached PC to perform
switch control logic
t
OpSw 28
c=Disable DS54 interrogate commands at
power on
t
OpSw 33
c=Allow track power to restore to prior state
at power on
t
OpSw 34
c=Allow track to power up to run state, if was
run prior to power own
t
OpSw 36*
c=Clear all mobile decoder information &
MU information in command station
t
OpSw 39*
c=Return DCS50 to factory option switch
settings
t
OpSw 43
c=Disable LocoNet up date of command
station's track status
t
OpSw 45
c=Disable reply for switch state request
t
50