Dinstar UC2000-VG - How to Trace SIP Logs; How to Trace ECC Logs (Call Details)

UC2000-VE/F/G GSM/CDMA/WCDMA VoIP Gateway User Manual
_______________________________________________________________________________
Shenzhen Dinstar Co., Ltd.
115
5.3.2 GENERAL PURPOSE COMMANDS IN "CONFIG" MODE
Set time (clock set)
Save the configuration (save)
Restart device (reset eia)
Enable debug
The command format is deb port + port number, to enable port 0 debug, as below:
To enable all ports debug, with the command “deb port all”
Without this steps, no trace logs will display on output window