Dinstar UC2000-VG - Basic Operation; Check IP Address; Restore Factory Setting via IVR

UC2000-VE/F/G GSM/CDMA/WCDMA VoIP Gateway User Manual
_______________________________________________________________________________
Shenzhen Dinstar Co., Ltd.
16
3 Basic Operation
3.1 FEATURE CODES
Users can do some basic system setting via dialing feature codes through a telephone.
The device has a built-in IVR navigator for local maintenance. In each step, if you hear
an IVR message of “setting succeeds”, it means you have finished this step
successfully. However, if you hear “setting fails”, please check and redo that step.
Code
Corresponding Function
*150*
Dial *150*1 to set the IP address of the gateway as static IP address; dial *150*2 to
set the IP address as DHCP IP address
*152*
Dial *152*192*168*1*10# to set the IP address of the device as 192.168.1.10.
( 192.168.1.10 is just an example)
*156*
Dial *156*192*168*1*1# to set the default gateway of the network as 192.168.1.1.
( 192.168.1.1 is just an example)
*153*
Dial *153*255*255*0*0*# to set the netmask of the network as 255.255.0.0
(255.255.0.0 is just an example)
*158#
Dial *158 to inquiry IP address of the device
*111#
Dial *111# to restart the device
3.2 BASIC OPERATION
3.2.1 Check IP address
Use a mobile phone to call a SIM card number of the device, then the device will
answer and play a voice prompt of ‘dial the extension number’. Press *158# on mobile
phone, then the device will report its local IP address automatically.
3.2.2 Restore factory setting via IVR
Use a mobile phone to call a SIM card number of the device, the device will answer and
play a voice prompt of ‘dial the extension number’. Press *166*000000# on the mobile