UC2000-VE/F/G GSM/CDMA/WCDMA VoIP Gateway User Manual
_______________________________________________________________________________
Shenzhen Dinstar Co., Ltd.
93
Counts of consecutive GSM Code: The counts of the error code consecutively.
As the figure shows above, once the GSM error code 8 is detected, the gateway will
blocked the gateway module.
PDD Less Than(1-30): define the value of abnormal PDD. You can check PDD value
under system information page.
Handle abnormal event
Once one of the above abnormal condition is detected, gateway could:
Reset the specified GSM module
Block the specified GSM module
Block the SIM, this setting only available while remote SIM mode is in using or
multiple SIM device.
SMS Test, send a SMS through specific port to verify if the SIM card works properly
Sending SMS to a phone number for alerting, this is optional.
USSD Event
Reset module/block Port/Block SIM card in case of USSD failed more than defined
value threshold.
USSD/SMS Monitor
This parameter be used to Monitor SMS/USSD response contents, which helps
gateway to know SIM card is blocked.
To Next Page
Loading...
