Operating Instructions RF-2000
49
To cancel this function, press shift and CE simultaneously.
LAMP ADJUST
(Lamp position adjustment)
EX(nm) EM(nm) Data
LAMP ADJUST
Press Enter to enter the xenon lamp position adjusting mode and the light source
intensity is displayed. For adjusting procedure, see section "4.7.1 Adjusting the light
source position."
S/N CHECK
(Performance check)
EX(nm) EM(nm) Data
S/N CHECK
Press Enter to go to the performance check mode.
In this mode, you can perform a sensitivity check, noise width measurement and
calculation of S/N value. The following message is retained on the screen, since the
parameter settings of the integrator must be changed for these measurements.
EX(nm) EM(nm) Data
S/N CHECK
ENTER
To continue the measurement, press Enter. To exit from this mode and return to the
initial screen, press CE.
To Next Page
Loading...
