Remote Controls
57
Recover Button
1
2
3
4
5
6
7
8
9
10
11
R
1
2
3
4
5
6
7
8
10
R
11
RECOVER
B
UTTON
Use RECOVER if you accidentally change the channel or video inp
ut on your TV and
cannot get the pictur
e back from your satellite receiv
er. When you press RECOVER as
described below, the remote control sends commands to your TV to ch
ange channels or
video inputs to try to get you back to wa
tching satellite program
ming. This
procedure
works only if you have accidentally changed the TV channel or video inpu
t. It does not
recover lost satellite signal (See
Troubleshooting on page 86 for information on solving
problems).
Note: The remote must be programmed to control the TV (and VCR, if ap
plicable) for
RECOVER to work as described.
Note: RECOVER will first try to tune your TV to
channel 3, then channe
l 4, and then other
video inputs with each press of RECOVER. You may need to pr
ess RECOVER up to 30
times to recover your
satellite TV video.
• The following setup is r
equired to use RECOVER:
• The remote control must be set up to control the TV and, if installed
, the VCR.
• If a VCR is installed, make sure it is connected as shown on p
age 76.
1
Make sure the TV is on.
2
Press and hold RECOVER until all four mode buttons light, and then
let go of the button.
The SAT mode button flashes twice and then
all four mode buttons flash three times.
3
Press RECOVER. Wait for the TV or VCR mode
button to flash once and then all four
mode buttons to flash once.
4
If you see the System Info scre
en, press the Select button to close the screen. You have
recovered your
satellite video.
5
If you do not see the System Info screen, repeat steps 3 and 4 until
you have recovered
your satellite video.
Note: Press any remote control button other than RECOVER to end this pr
ocedure.
To Next Page
Loading...
