Controls - 26 JT40/JT40 All Terrain Operator’s Manual
Set-Up Console
6. Engine stop To stop engine, press red
button.
IMPORTANT: To restart engine, turn
ignition switch off and then back on.
7. Drive mode switch To select normal driving mode
(high), move up.
To select loading and
unloading mode (low), move
down.
8. Left multifunction
joystick
Move joystick to control
selected system.
See “Multifunction Joystick Control
Modes” on page 27.
9. Throttle switch To increase engine speed,
move up.
To decrease engine speed,
move down.
Release switch to stop speed
adjustment.
IMPORTANT: Switch only works
when controller is in the ready mode
(green LED blinking) and at least one
operator presence switch is pressed.
10. Menu select switch To move up through the
modes on the transmitter
move up.
To move down through the
modes on the transmitter
move down.
Release switch to stop
moving through modes.
IMPORTANT: Operator presence
switches must be released and
pressed again after changing modes
to enable new function. See “Operator
presence switches” on page 24.
11. LCD display Indicates the selected mode
of operation.
Item Description Notes
To Next Page
Loading...
