DITEC EL500E - Push Buttons; Additional Control Buttons

9
IP2358EN
2.2 MOTOR POWER SUPPLY
IMPORTANT! All the connection operations must be performed only after the main power supply has been dis-
connected.
TURN OFF THE MAIN POWER SWITCH BEFORE ANY OTHER OPERATION!
After installation it is possible to connect motor and central unit with
cable Ditec NRGCAB:
• Connect free wires to the X2 terminal (as shown here on the side),
and verify the direction of the motor rotation.
• Link the ground conductor to connector X16.
WARNING! Verify the direction of rotation of the motor supplied with
400V or 230V 3-phase : by pressing the OPEN button (S2) the door
has to open while, by pressing the CLOSE button (S3), the door
must close.
In case of wrong direction, reverse two of the phases (L1, L2 and
L3) on the X1 terminal.
3. PUSH BUTTONS
The keyboard on the cover of the control unit is connected to terminal X5 through the flat cable (A): if you need to dis-
connect the flat and then to reconnect it, pay attention to the direction of connection (reference point B).
3.1 ADDITIONAL CONTROL BUTTONS
B
X5
A
1
2
3
4
5
6
7
8
9
1
0
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
2
2
2
2
C
L
OS
E
O
PEN
S
T
O
P
X
3
X
X
To do it:
1. connect a normally closed button, eliminating the standard jumper, to
the contacts 3 and 4 for the STOP command;
2. connect a normally open button to the contacts [5] and [6] for the OPEN
command (S2);
3. connect a normally open button to the contacts [7] and [8] for the CLOSE
command (S3).
PAY ATTENTION AT THE CONNECTIONS! No line voltage (230V~ or
other external devices) can be connected to the buttons otherwise
the unit is damaged.
You can connect additional control
pushbuttons through the terminals
from 3 to 8 of the X3.
UV W
PE PE PE PE
WIRE
JUMPER
NRGCAB
X16
X2
M