dji AIR 3S - Hyperlapse; Using Hyperlapse

3. Tap or press the Flight Pause button on the remote controller once. The aircraft will
exit QuickShots immediately and hover.
4.4 Hyperlapse
It is recommended to click the link below or scan the QR code to watch the tutorial video.
https://www.dji.com/air-3s/video
Hyperlapse takes a certain number of photos according to the time interval, and then
compiles these photos into a video of a few seconds. It is especially suitable for recording
scenes with moving elements, such as trac ow, clouds drifting, and sunrises and
sunsets.
• For optimal performance, it is recommended to use Hyperlapse at an altitude
higher than 50 m and set a dierence of at least two seconds between the
interval time and shutter speed.
• It is recommended to select a static subject (e.g., high-rise buildings,
mountainous terrain) located at a safe distance from the aircraft (further than
15 m). DO NOT select a subject that is too close to the aircraft, people, or a
moving car, etc.
• When the lighting is sucient and the environment is suitable for the vision
system, the aircraft will brake and hover in place if an obstacle is detected
during Hyperlapse. If the lighting becomes insucient or the environment is
unsuitable for the vision system to operate during Hyperlapse, in this case, pay
attention to the status of the vision system in the app. If it indicates that the
vision system in a certain direction is disabled, the aircraft will not be able to
avoid obstacles in that direction. Fly with caution.
Using Hyperlapse
1. Tap the Shooting Modes icon from the camera view and select Hyperlapse .
DJI Air 3S User Manual
34 © 2024 DJI All Rights Reserved.