EasyManua.ls Logo

dji AIR 3S - Notice

dji AIR 3S
94 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
the camera orientation or pressing the customizable buttons on the remote
controller to recenter the camera will stop the aircraft from automatically
adjusting the gimbal tilt, which may prevent the AR RTH route from being
viewed.
Notice
The aircraft may not be able to return to the Home Point as normal if the
positioning system is functioning abnormally. During Failsafe RTH, the aircraft
may enter ATTI mode and land automatically if the positioning system is
functioning abnormally.
When there is no GNSS, do not y over water surfaces, buildings with glass
surface, or in scenarios where the altitude above the ground is greater than
30 meters. If the positioning system is functioning abnormally, the aircraft will
enter ATTI mode.
It is important to set a suitable RTH altitude before each ight. Launch DJI Fly
and set the RTH altitude. The default RTH altitude is 100 m.
The aircraft cannot sense obstacles during RTH if the environment conditions
are not suitable for the sensing system.
GEO zones may aect the RTH. Avoid ying near GEO zones.
The aircraft may not be able to return to a Home Point if the wind speed is too
high. Fly with caution.
Pay extra attention to small or ne objects (such as tree branches or power
lines) or transparent objects (such as water or glass) during RTH. Exit RTH and
control the aircraft manually in an emergency.
Set Advanced RTH as Preset if there are power lines or transmission towers that
the aircraft cannot bypass on the RTH path and make sure the RTH Altitude is
set higher than all obstacles.
The aircraft will brake and return to home according to the latest settings if the
Advanced RTH settings in DJI Fly are changed during RTH.
If the max altitude is adjusted below the current altitude during RTH, the aircraft
will descend to the max altitude rst and then continue returning to home.
The RTH Altitude cannot be changed during RTH.
If there is a large dierence between the current altitude and the RTH altitude,
the amount of battery power used cannot be calculated accurately due to wind
speed dierences at dierent altitudes. Pay extra attention to the battery power
prompts and warning prompts in DJI Fly.
DJI Air 3S User Manual
42 © 2024 DJI All Rights Reserved.

Table of Contents

Related product manuals