EasyManua.ls Logo

dji AIR 3S - FAR Remote ID Compliance Information

dji AIR 3S
94 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Ground
Warning Zones
1. UA can take o and y into these zones with a
warning message
When the aircraft and DJI Fly app cannot obtain a GPS signal, the GEO
awareness function will be inoperative. Interference of the aircraft antenna or
disabling the GPS authorization in DJI Fly will cause the GPS signal fails to be
obtained.
EASA Notice
Make sure to read the Drone Information Notices document included in the package
before use.
Visit the link below for more EASA notice information on traceability.
https://www.easa.europa.eu/en/document-library/general-publications/drones-
information-notices
Original Instructions
This manual is provided by SZ DJI Technology, Inc., and the content is subject to change.
Address: Lobby of T2, DJI Sky City, No. 53 Xianyuan Road, Xili Community, Xili Street,
Nanshan District, Shenzhen, China, 518055.
7.12 FAR Remote ID Compliance Information
The unmanned aircraft system is equipped with a Remote ID system that meets the
requirements of 14 CFR Part 89.
The aircraft automatically broadcasts Remote ID messages from takeo to shutdown.
An external device such as a cell phone or tablet is required to be connected as a
location source to DJI mobile devices without an integrated GNSS system,
[1]
and must
run the DJI ight control app such as DJI Fly in the foreground and always allow the DJI
ight control app to obtain its accurate location information. The connected external
device must minimally be one of the following:
DJI Air 3S User Manual
92 © 2024 DJI All Rights Reserved.

Table of Contents

Related product manuals