• The DJI Cellular Dongle 2 and its related service are only available in some
countries and regions. Comply with local laws and regulations and DJI Cellular
Dongle Terms of Service.
The installation requirements are as shown below:
• The aircraft needs to be installed with a DJI Cellular Dongle 2, and a nano-SIM card
should be installed into the dongle in advance. Both the DJI Cellular Dongle 2 and the
nano-SIM card need to be purchased separately.
• The DJI RC 2 remote controller can connect to a Wi-Fi hotspot to use Enhanced
Transmission.
• The DJI RC-N3 remote controller utilizes the 4G network of the mobile device for
Enhanced Transmission.
Enhanced Transmission consumes data. If the transmission completely switches to a 4G
network, a 30-minute ight consumes about 1 GB of data on the aircraft and the remote
controller, respectively. This value is for reference only. Refer to the actual data usage.
Installing the nano-SIM Card
Open the SIM card slot cover on the dongle, insert the nano-SIM card into the slot in the
same direction as shown in the gure, and then close the cover.
• It is strongly recommended to purchase a nano-SIM card which supports a 4G
network from ocial channels of the local mobile network operator.
• DO NOT use an IoT SIM card, otherwise the video transmission quality will be
seriously compromised.
• DO NOT use a SIM card provided by the virtual mobile network operator,
otherwise it may lead to an inability to connect to the Internet.
• DO NOT cut the SIM card by yourself, otherwise the SIM card may be damaged,
or the rough edges and corners may cause the SIM card to be unable to be
inserted or removed properly.
DJI Air 3S User Manual
© 2024 DJI All Rights Reserved. 81
To Next Page
Loading...
