Landing Protection
If Obstacle Avoidance Action is set to Bypass or Brake, Landing Protection will be
activated when you push the throttle stick down to land the aircraft. Landing Protection is
enabled once the aircraft begins to land.
• If the ground is determined to be suitable for landing, the aircraft will land directly.
• If the ground is determined to be unsuitable for landing, the aircraft will hover when
the aircraft descends to a certain height above ground. Push down on the throttle
stick for at least ve seconds, and the aircraft will land without obstacle sensing.
5.6 Vision Assist
The vision assist view, powered by the vision systems, changes the image on the view
from the corresponding vision sensors according to the ight speed direction to help
users navigate and observe obstacles during ight. Swipe left on the attitude indicator,
right on the mini map, or tap the icon in the lower right corner of the attitude indicator to
switch to the vision assist view.
• When using vision assist, the quality of the video transmission may be lower
due to transmission bandwidth limits, cell phone performance, or the video
transmission resolution of the screen on the remote controller.
• It is normal for propellers to appear in the vision assist view.
• Vision assist should be used for reference only. Glass walls and small objects
such as tree branches, electric wires, and kite strings cannot be displayed
accurately.
• Vision assist is not available when the aircraft has not taken o or when the
video transmission signal is weak.
Tap the arrow to switch between dierent directions of the vision assist view. Tap and
hold to lock the direction. Tap the center of the screen to maximize the vision assist view.
DJI Air 3S User Manual
© 2024 DJI All Rights Reserved. 53
To Next Page
Loading...
