dji AIR 3S - Battery Protection Mechanisms; Gimbal and Camera; Gimbal Notice

Battery Protection Mechanisms
The battery level LEDs can display battery protection notications triggered by abnormal
charging conditions.
LEDs Blinking Pattern Status
LED2 blinks twice per second Overcurrent detected
LED2 blinks three times per second Short circuit detected
LED3 blinks twice per second Overcharge detected
LED3 blinks three times per second Over-voltage charger detected
LED4 blinks twice per second Charging temperature is too low
LED4 blinks three times per second Charging temperature is too high
If any of the battery protection mechanisms are activated, unplug the charger, and plug it
in again to resume charging. If the charging temperature is abnormal, wait for it to return
to normal. The battery will automatically resume charging without the need to unplug
and plug in the charger again.
5.9 Gimbal and Camera
Gimbal Notice
• Make sure there are no stickers or objects on the gimbal before taking o. DO
NOT tap or knock the gimbal after the aircraft is powered on. Launch the aircraft
from open and at ground to protect the gimbal.
• After installing the wide-angle lens, unfold the arms before powering on the
aircraft. Make sure the gimbal is level and pointing forward before takeo, so
that the aircraft can correctly detect the installation status of the wide-angle
lens. The gimbal will be level when the aircraft is powered on, if the gimbal
rotates, recenter the gimbal using the remote controller or DJI Fly as follows:
◆
In the camera view of DJI Fly, tap > Control > Recenter Gimbal.
◆
Press the button that is used to control gimbal recenter/down on the remote
controller.
• Pano and Asteroid functions will not be available after the wide-angle lens is
installed.
• Remove the gimbal protector before powering on the aircraft. Attach the gimbal
protector when the aircraft is not in use.
DJI Air 3S User Manual
62 © 2024 DJI All Rights Reserved.