dji AIR 3S - Notice

environment. APAS makes it easier to avoid obstacles, obtain smoother footage, and give
a better ying experience.
When APAS is enabled, the aircraft can be stopped by pressing the Flight Pause button
on the remote controller. The aircraft brakes and hovers for three seconds and awaits
further pilot commands.
To enable APAS, open DJI Fly, go to > Safety > Obstacle Avoidance Action, and
select Bypass. Set Bypassing Options to Normal or Nifty. In Nifty mode, the aircraft can
y faster, smoother, and closer to obstacles obtaining better footage while bypassing
obstacles. However, the risk of crashing into obstacles will increase. Fly with caution.
Nifty mode cannot work normally in the following situations:
• When aircraft orientation changes rapidly ying near obstacles.
• When ying through narrow obstacles such as canopies or bushes at high speed.
• When ying near obstacles that are too small to detect.
• When ying with the propeller guard.
Notice
• Make sure to use APAS when the vision system is available. Make sure there
are no people, animals, objects with small surface areas (e.g., tree branches), or
transparent objects (e.g., glass or water) along the desired ight path.
• Make sure to use APAS when the downward vision system is available or the
GNSS signal is strong. APAS may not function properly when the aircraft is ying
over water or snow-covered areas.
• Be extra cautious when ying in extremely dark (<300 lux) or bright (>10,000 lux)
environments.
• Pay attention to DJI Fly and make sure APAS is working normally.
• APAS may not function properly when the aircraft is ying near ight limits or in
a GEO zone.
• When the lighting becomes insucient and the vision system is partially
unavailable, the aircraft will switch from bypassing obstacles to braking and
hovering. You need to center the control stick and then to continue controlling
the aircraft.
DJI Air 3S User Manual
52 © 2024 DJI All Rights Reserved.