• Make sure to follow all the steps to update the rmware, otherwise the update
may fail.
• Make sure the computer is connected to the internet during the update.
• DO NOT unplug the USB-C cable during an update.
• Before performing an update, make sure the Intelligent Flight Battery is at least
40% charged and the remote controller is at least 20% charged.
• The rmware update will take approximately 10 minutes. During the update
process, it is normal for the gimbal to go limp, the aircraft status indicators to
blink, and the aircraft to reboot. Wait patiently for the update to complete.
Visit the following link and refer to the Release Notes for rmware update information:
https://www.dji.com/air-3s/downloads
7.4 Flight Recorder
Flight data including ight telemetry, aircraft status information, and other parameters
are automatically saved to the internal data recorder of the aircraft. The data can be
accessed using DJI Assistant 2 (Consumer Drones Series).
7.5 Enhanced Transmission
It is recommended to click the link below or scan the QR code to watch the tutorial video
for installation and usage methods.
https://www.dji.com/air-3s/video
Enhanced Transmission integrates OcuSync video transmission technology with 4G
networks. If the OcuSync video transmission is obstructed, experiencing interference, or
used over long distances, 4G connectivity allows you to maintain aircraft control.
• Enhanced Transmission is only supported in some countries and regions.
DJI Air 3S User Manual
80 © 2024 DJI All Rights Reserved.
To Next Page
Loading...
