dji AIR 3S - Page 66

• In the DJI Fly camera view, tap > Camera to enable or disable Allow
QuickTransfer in Sleep.
• After enabling Allow QuickTransfer in Sleep, the aircraft will enter sleep mode
after powering o, allowing you to use the QuickTransfer function. Sleep mode
will automatically turn o after 12 hours of inactivity or when the battery is
replaced. To restore sleep mode, press the power button once and wait for
about 15 seconds.
• When using Allow QuickTransfer in Sleep, only the battery level LEDs will be on.
If the mobile device and the aircraft are not connected via Wi-Fi or if the app is
exited (and there are no ongoing download tasks) for more than 1 minute, the
QuickTransfer will automatically exit, and the aircraft will return to sleep mode.
• The maximum download rate can only be achieved in countries and regions
where the 5.8GHz frequency is permitted by laws and regulations, when using
devices that support 5.8GHz frequency band and Wi-Fi connection, and in an
environment without interference or obstruction. If 5.8GHz is not allowed by
local regulations (such as in Japan), or your mobile device does not support
the 5.8GHz frequency band, or the environment has severe interference, then
QuickTransfer will use the 2.4GHz frequency band and its maximum download
rate will reduce to 6MB/s.
• When using QuickTransfer, it is not necessary to enter the Wi-Fi password on
the settings page of the mobile device in order to connect. Launch DJI Fly and a
prompt will appear to connect the aircraft.
• Use QuickTransfer in an unobstructed environment with no interference and
stay away from sources of interference such as wireless routers, Bluetooth
speakers, or headphones.
DJI Air 3S User Manual
66 © 2024 DJI All Rights Reserved.