DLS FlexxPump 125 - Transport and Storage; 4.1 Packaging; 4.2 Transport Guidelines; 4.3 Storage Instructions

revision: 0
FlexxPump 125 (24V)
User Manual
14
EN-
SCHMIERSYSTEME
DIRECT LUBRICATION SYSTEMS
D L S
4. Transport and storage
4.1 Packaging
The FlexxPump 125 is delivered in an outer packaging ( cardboard box ) and - depen-
ding on the scope of delivery with a lubricant cartridge and other accessories - in the
same package. To protect them from moisture and dirt, they are also packed in PE
lms. As a preventive protective measure against the escape of the prelled lubricant
from the FlexxPump 125, appropriate protective caps are tted on the lubricant supply
and at the lubricant outlet.
Dispose the packaging materials at the designated disposal points in compliance with
the relevant national and company regulations.
After receiving the FlexxPump 125, check the delivery note for completeness and
correctness.
Any missing parts or damage must be reported immediately to the forwarding agent,
the insurance company or DLS Schmiersysteme GmbH in writing.
4.2 Transport
NOTICE
Hard shocks, e.g. due to falling or setting down too hard, can
damage the FlexxPump 125.
§ Do not throw the FlexxPump 125.
Hard shocks, e.g. due to falling or setting down too hard, can damage the Flexx-
Pump 125.
§ Do not throw the FlexxPump 125.
§ When using lifting equipment, only use hoists and load
handling attachments in perfect condition and with su󰀩cient
load capacity.
§ The permissible lifting weight of the lifting device must not be
exceeded.
4.3 Storage