DLS FlexxPump 125 - 2.5 Intended Purpose; 2.6 Warranty and Liability Exclusions

revision: 0
FlexxPump 125 (24V)
User Manual
09
EN-
SCHMIERSYSTEME
DIRECT LUBRICATION SYSTEMS
D L S
2.5 Usage for the intended purpose
The following points must be observed for the intended purpose of using the Flexx-
Pump 125:
+ The FlexxPump 125 is exclusively approved for industrial use.
+ The FlexxPump 125 may be used exclusively in accordance with the technical data
(chapter 3.4).
+ Unauthorized structural alterations to the FlexxPump 125 are not permitted.
+ Read the user manual and act accordingly.
+ During operation of the FlexxPump 125, a visual inspection of the FlexxPump 125
as well as of the lubrication point must be carried out regularly. Any anomalies must
be eliminated immediately and the cause rectied.
+ Relling the cartridge is not permitted.
+ The FlexxPump 125 may not be opened or disassembled.
+ Only lubricants approved by the manufacturer may be used.
+ Relevant regulations and rules on work safety, accident prevention and environmen-
tal protection must be observed.
+ Work and activities with and on the FlexxPump 125 are only permitted with appropri-
ate authorisation (chapter 2.3).
All other uses than the aforementioned intended usage or the disregard of one of the
above points shall be deemed improper usage. In this case no liability and/or warranty
is assumed.
2.6 Warranty and Liabilty
If the following items are disregarded, all warranty and liability claims for personal injury
and/or damage to property are excluded:
+ Non-observance of the instructions for transport and storage;
+ Misuse;
+ Improper or unperformed maintenance or repair work;
+ Improper assembly / disassembly or improper operation;
+ Operation of the FlexxPump 125 with defective protective devices and devices;
+ Operation of the FlexxPump 125 without lubricant;
+ Operation of the FlexxPump 125 with non-approved lubricant;
+ Operation of heavily contaminated FlexxPump 125;
+ Modications or alterations which may be carried out without the written permission of
DLS Schmiersysteme GmbH have taken place;
+ Opening and/or partial or complete disassembly of the FlexxPump 125.