DLS FlexxPump 125 - 9.2 Cartridge Change Procedure

revision: 0
FlexxPump 125 (24V)
User Manual
67
EN-
SCHMIERSYSTEME
DIRECT LUBRICATION SYSTEMS
D L S
9.2 Cartridge change
The cartridge only needs to be changed if it is empty or the service life of the lubricant
has been exceeded. The cartridge can be changed during normal operation of the
FlexxPump 125. Apart from changing the cartridge, no other measures are necessary!
FlexxPump 125 has a fault (Error E1); the red LED flashes every 5 seconds.
NOTICE
A used lubricant cartridge must not be replaced on the Flexx-
Pump 125, as the integrated stroke counter of the FlexxPump
125 is automatically reset by the cartridge sensor after a car-
tridge has been removed.
§ Only use full lubricant cartridges.
NOTICE
Only use original lubricant cartridges with lubricant approved
by the manufacturer.
§ Observe the maximum shelf life of lubricant lled in cartridges.
NOTICE
It is not possible to rell empty or opened lubricant cartridges.

NOTICE
Make sure you use the same lubricant in the new cartridge that
is already in use.
§ Compare the data on the lubricant cartridge.
