revision: 0
FlexxPump 125 (24V)
User Manual
69
EN-
SCHMIERSYSTEME
DIRECT LUBRICATION SYSTEMS
D L S
Carry out the work as described above (steps 1 and 2).
Ü If an error was displayed in the LCD before changing the cartridge or battery, the
message will now disappear, as will the ashing red LED. A separate conrmation is not
necessary. The green LED ashes briey every 5 seconds.
Ü The FlexxPump 125 automatically returns to the last active mode (ON or OFF) befo-
re the completion of this work.
If the empty state of the cartridge (Error E1) was reached during a dispensing cycle,
it is automatically interrupted and continued automatically after completion of the work
explained above.
9.3 Disposal
When disposing the FlexxPump 125, empty or opened cartridges, observe the rele-
vant national regulations in force.
When disposing the FlexxPump 125, observe the relevant safety data sheets and
disposal instructions for the individual components.
It is not possible to refill empty lubricant cartridges.
To Next Page
Loading...
