revision: 0
FlexxPump 125 (24V)
User Manual
15
EN-
SCHMIERSYSTEME
DIRECT LUBRICATION SYSTEMS
D L S
5. Mounting
5.1 Preparations
Before starting to work, inform yourself in detail about the FlexxPump 125 using this
user manual; in particular about the general safety instructions (chapter 2.7). Prepare
the installation site carefully.
NOTICE
Pressurised air can damage the seals of the FlexxPump 125
and can transport dirt and foreign matter into the FlexxPump
125 or the lubricant.
§ Do not use pressurised air.
§ Make sure that there is no coarse dirt in the mounting area.
2. Remove protective cap from top of the
FlexxPump 125.
Remove the yellow protective cap from
the top of the lubricant inlet of the Flexx-
Pump 125.
Make sure that no dirt, water or foreign
bodies enters the lubricant inlet.
5.2 Assembly
1. Condition as delivered
The FlexxPump 125 is delivered in a
cardboard box. Depending on the version
ordered, further accessories such as battery,
lubricant cartridge or additional tube connec-
tion parts are included.
To Next Page
Loading...
