revision: 0
FlexxPump 125 (24V)
User Manual
56
EN-
SCHMIERSYSTEME
DIRECT LUBRICATION SYSTEMS
D L S
8.2.3 Control signal 14 seconds
The control signal 14 seconds is used to acknowledge error messages of errors E2 and
E3. It is the only control signal that the FlexxPump 125 can process when a low level
output signal is sent. Irrespective of the basic possibility of remote acknowledgement
of an error, it is essential to identify and eliminate the cause when an error message is
present.
U
24V
0V
t
PIN 2
U
24V
0V
t
PIN 4
10s
>3s
o.E.
o.E.
14s
To Next Page
Loading...
