DLS FlexxPump 125 - Page 4

revision: 0
FlexxPump 125 (24V)
User Manual
04
EN-
SCHMIERSYSTEME
DIRECT LUBRICATION SYSTEMS
D L S
6.2 Factory settings 20
6.2.1 Default settings operating mode Hour-Mode -h- 20
6.2.2 Default setting operating mode Empty-Time-Mode Et 21
6.2.3 Default setting operating mode Pulse-Control-Mode PUL 21
6.3 Menu and LCD messages 22
6.3.1 LCD 25
6.3.2 Actions with the activation and programming key 28
6.3.3 Switching on and o󰀨 30
6.3.4 INF-Menu operating mode Hour-Mode -h- 31
6.3.5 INF-Menu operating mode Empty-Time-Mode Et 32
6.3.6 INF-Menu operating mode Pulse-Control-Mode PUL 33
6.3.7 SET-Menu 34
6.3.8 RUN-Menu 36
6.3.9 PRO-Menu operating mode Hour-Mode -h- 38
6.3.10 PRO-Menu operating mode Empty-Time-Mode Et 41
6.3.11 PRO-Menu operating mode Pulse-Control-Mode PUL 43
6.3.12 FIL-Menu 44
6.4 Error codes 45
7. Input and output signals - Time Control 47
7.1 Pin assignment - Time control 47
7.2 Output signals and LCD messages - Time control 47
7.3 Output signals at PIN 4 - Time control 48
8. Input and output signals - External control (PLC) 50
8.1 Pin assignment - External control (PLC) 50
8.2 Input signals - External control (PLC) 51
8.2.1 Control signal 2 seconds 52
8.2.2 Control signal 12 seconds 54
8.2.3 Control signal 14 seconds 56
8.3 Output signals/LCD messages - External control (PLC) 58
8.3.1 Error E1 (empty level) - External control (PLC) 59
8.3.2 Error E1 (No cartridge mounted) - External control (PLC) 61
8.3.3 Error E2 (overload) - External control (PLC) 62
8.3.4 Error E3 (undervoltage) - External control (PLC) 63
8.3.5 Error E4 (Critical error) - External control (PLC) 64
9. Maintenance and disposal 65
9.1 Maintenance schedule 65
9.1.1 Visual check 66
9.1.2 Cleaning 66
9.1.3 Recommissioning after maintenance 66
9.2 Cartridge change 67
9.3 Disposal 69
Chapter Content Page