revision: 1
FlexxPump 250/400 DLS
User Manual
24
EN-
7. Operation and settings
7.1 General information
What you should know about operating and setting the FlexxPump 250/400 DLS:
D For operation, the FlexxPump 250/400 DLS must be integrated into a
control system (PLC) and must be commanded and controlled via the PLC.
The FlexxPump 250/400 DLS delivers one or more strokes (one stroke =
0.15 cm³) depending on the signals of the external control (PLC). Depending on
the internal status of the FlexxPump 250/400 DLS (e.g. cartridge empty), different
output signals are issued by the FlexxPump 250/400 DLS.
D The disposable interchangeable cartridge with 250ml or 400ml lubricant
guarantees a controlled and constant quality of the lubricant and is lled without
air bubble inclusions. The FlexxPump 250/400 DLS allows a high supply security
of the lubrication point and prevents failures. The FlexxPump 250/400 DLS in its
present version is designed exclusively for the lubricant grease.
D The FlexxPump 250/400 DLS cannot be used in the present version without a
lubricant cartridge. Depending on the version ordered the cartridge can already
be included in the scope of delivery and may already be connected and installed
in the FlexxPump 250/400 DLS.
D If you have any questions about your application and the correct settings for
FlexxPump 250/400 DLS, please contact the manufacturer (chapter I.II).
Make sure that your PLC program is correct for your application and that the
lubrication point is supplied with the correct amount of lubricant per time unit.
If this is the case, you can operate the FlexxPump 250/400 DLS.
If this is not the case, change your PLC program accordingly.
To use the FlexxPump 250/400 DLS, it rst has to be properly mounted and installed.
The installation is very simple and described in detail in chapter 6.2.
If you order a special version of the FlexxPump 250/400 DLS from the factory, the
information on the supplement sheet is decisive for you!
To Next Page
Loading...