revision: 1
FlexxPump 250/400 DLS
User Manual
19
EN-
6. Mounting
6.1 Preparations
Before starting to work, inform yourself in detail about the FlexxPump 250/400 DLS
using this user manual; in particular about the general safety instructions (section 2.7).
Prepare the installation site carefully.
NOTICE
Pressurised air can damage the seals of the Flexx-
Pump 250/400 DLS and can transport dirt and foreign matter
into the FlexxPump 250/400 DLS or the lubricant.
§ Do not use pressurised air.
§ Make sure that there is no coarse dirt in the mounting area.
2. Remove the housing from the power unit
of the FlexxPump 250/400 DLS.
Separate the housing from the
power unit by turning the retaining ring
counterclockwise.
Make sure that no dirt, water or foreign
bodies enters the lubricant inlet.
6.2 Assembly
1. Condition as delivered
The FlexxPump 250/400 DLS is delivered in
a cardboard box. Depending on the version
ordered, further accessories such as a lubri-
cant cartridge or additional tube connection
parts are included.
To Next Page
Loading...