DLS FlexxPump 250 DLS - Lubricants; Tube lengths

revision: 1
FlexxPump 250/400 DLS
User Manual
51
EN-
10.1 Tube lengths
In principle, the recommendation is to install the FlexxPump 250/400 DLS as close as
possible to the consumer (lubrication point). Ideally, this should be done directly at or
on the lubrication point. In cases where this is not possible due to the installation space
or for reasons of reachability or accessibility, tubes can also be used between the
FlexxPump 250/400 DLS and the lubrication point (or distributor).
If the case arises that you cannot mount the FlexxPump 250/400 DLS directly
at the lubrication point, contact the manufacturer to verify your application. The
inuence of temperature, the grease used, the hoses and accessories used does
not allow a general statement to be made about the possible hose length on the
FlexxPump 250/400 DLS.
10.2 Lubricants
Only use lubricants approved by the manufacturer DLS Schmiersysteme GmbH
in the original cartridges developed and manufactured exclusively for
FlexxPump 250/400 DLS.
NOTICE
The lubricant used in each case differs according to the appli-
cation. The respective designation can be found on the label of
the cartridge.

Further information on lubricants, documentation and safety data sheets can be ob-
tained directly from the manufacturer DLS Schmiersysteme GmbH.