DLS FlexxPump 250 DLS - Cartridge change

revision: 1
FlexxPump 250/400 DLS
User Manual
45
EN-
9.2 Cartridge change
The cartridge only needs to be changed if it is empty or the service life of the lubricant
has been exceeded. The cartridge can be changed during normal operation of the
FlexxPump 250/400 DLS.
NOTICE
A used lubricant cartridge must not be replaced on the Flexx-
Pump 250/400 DLS, as the integrated stroke counter of the
FlexxPump 250/400 DLS is automatically reset by the cartridge
sensor after a cartridge has been removed.
§ Only use full lubricant cartridges.
NOTICE
Only use original lubricant cartridges with lubricant approved
by the manufacturer.
§ Observe the maximum shelf life of lubricant lled in cartridges.
NOTICE
It is not possible to rell empty or opened lubricant cartridges.

NOTICE
Make sure you use the same lubricant in the new cartridge that
is already in use.
§ Compare the data on the lubricant cartridge.
