DLS FlexxPump 250 DLS - Usage for the Intended Purpose; Warranty and Liability

revision: 1
FlexxPump 250/400 DLS
User Manual
08
EN-
2.5 Usage for the intended purpose
The following points must be observed for the intended purpose of using the
FlexxPump 250/400 DLS:
+ The FlexxPump 250/400 DLS is exclusively approved for industrial use.
+ The FlexxPump 250/400 DLS may be used exclusively in accordance with the
technical data (chapter 3.4).
+ Unauthorized structural alterations to the FlexxPump 250/400 DLS are not
permitted.
+ Read the user manual and act accordingly.
+ During operation of the FlexxPump 250/400 DLS, a visual inspection of the
FlexxPump 400/200 DLS as well as of the lubrication point must be carried out
regularly. Any anomalies must be eliminated immediately and the cause rectied.
+ Relling the cartridge is not permitted.
+ The FlexxPump 250/400 DLS may not be opened or disassembled.
+ Only lubricants approved by the manufacturer may be used.
+ Relevant regulations and rules on work safety, accident prevention and
environmental protection must be observed.
+ Work and activities with and on the FlexxPump 250/400 DLS are only permitted
with appropriate authorisation (chapter 2.3).
All other uses than the aforementioned intended usage or the disregard of one of the
above points shall be deemed improper usage. In this case no liability and/or warranty
is assumed.
2.6 Warranty and Liability
If the following items are disregarded, all warranty and liability claims for personal injury
and/or damage to property are excluded:
+ Non-observance of the instructions for transport and storage;
+ misuse;
+ Improper or unperformed maintenance or repair work;
+ Improper assembly / disassembly or improper operation;
+ Operation of the FlexxPump 250/400 DLS with defective protective devices and
devices;
+ Operation of the FlexxPump 250/400 DLS without lubricant;
+ Operation of the FlexxPump 250/400 DLS with non-approved lubricant;
+ Operation of heavily contaminated FlexxPump 250/400 DLS;
+ Modications or alterations which may be carried out without the written
permission of DLS Schmiersysteme GmbH have taken place;
+ Opening and/or partial or complete disassembly of the FlexxPump 250/400 DLS.