ANNEX VII: Control Panel
Single Brake Test
The operation must be performed by qualified personnel.
1. Press BRAKE button
2. Turn BRAKE key on position 1 to open First Brake
or on 2 to open second Brake.
Test can be made only:
a) With cabin stationary and doors closed;
b) During test 3 and test 4 (measurement of stopping distance
at nominal speed)
c) During deceleration and standard stop (to check Contactor
locked fault)
Over Speed Governor Test
The operation must be performed by qualified personnel.
Operate on OSG Key:
• Activating of the OSG: turn to SET;
• Reset: Turn PME Selector to INSPECTION and
turn OSG key to RESET.
To Next Page
Loading...