DMP Electronics XR150FC - Page 39

Digital Monitoring Products, Inc. | XR Fire Control Panel User Guide 33
4. At the PROFILE NO option, enter a profile number and press COMMAND.
The display changes to PROFILENAME.
5. Press any Select Key to display -.
6. Enter a profile name of up to 16 characters. The default Profile Name uses
the Profile Number.
7. Enter the Profile Name and press COMMAND.
8. At the ARM/DIS AREAS option, enter the area numbers (1-32) for arming
and disarming assigned to this profile.
9. At ACCESSAREAS, enter the area numbers (1-32) assignment to allow
door access for this profile. Press COMMAND.
10. At OUTPUTGROUP, Enter the number (1 through 20) for the Output Group
assigned to this profile. Press COMMAND.
11. The keypad displays each of the menus as shown in the Profile References
Table. Enable or disable the menu function for this profile number. Select
YES or NO and press COMMAND to advance to the next menu selection.
12. After all User Profile menu assignments are selected, the keypad displays
the PROFILE CHNGD message for 4 seconds, indicating the profile is
changed.