What does 'SYSTEM BUSY' mean on my DMP Electronics Control Panel?
If your DMP Electronics Control Panel displays 'SYSTEM BUSY', wait a few moments for the system to complete the task. Ensure the RESET jumper is not on the panel. If the message persists for several minutes, the keypad is not receiving polling from the panel.
Why does my DMP Electronics Control Panel keypad display 'SYSTEM TROUBLE'?
If your DMP Electronics Control Panel keypad displays 'SYSTEM TROUBLE', it could be due to several reasons. First, check if the RESET jumper is installed and remove it. Second, inspect the green data wire for any breaks or shorts between the panel and the keypad. Finally, a faulty keypad or zone expander affecting the green data wire may be the cause; in this case, consider replacing the keypad or zone expander.
Why does my DMP Electronics XT30 keypad operate intermittently?
If your DMP Electronics Control Panel keypad operates intermittently, misses keystrokes, or the display doesn't update consistently, the wire length might exceed the maximum, causing poor data performance. Try reducing the wire length or using a heavier gauge wire.
Why is the Wireless Green TX LED off on my DMP Electronics XT30 Control Panel?
If the Wireless Green TX LED is off on your DMP Electronics Control Panel, it indicates that the Wireless House Code is not programmed. Program the House Code in System Options.
Why are both Green TX and Yellow RX LEDs on steady on my DMP Electronics Control Panel?
If both the Green TX and Yellow RX LEDs are on steady on your DMP Electronics Control Panel, it could be because the panel is reset. Remove the RESET jumper. Another possibility is that Flash Load is enabled; in this case, remove the LOAD jumper and reset the panel.
What to do if the Yellow RX LED never flashes on my DMP Electronics XT30?
If the Yellow RX LED on your DMP Electronics Control Panel never flashes, it may indicate that the transmitters are not getting through to the receiver. Begin by checking the transmitter serial numbers. Also, try moving the transmitter closer. If you are using an XT30, consider replacing the 1100 series receiver.
Why is the RCV Yellow LED off on my DMP Electronics XT30 Control Panel keypad?
If the RCV Yellow LED on your DMP Electronics Control Panel keypad is off, it could mean that the keypad/expanders are not connected to the panel. Connect the keypad/expanders. Alternatively, you may have more than eight keypads/expanders. Check the keypad/expander addresses.
Why is the XMIT Green LED off on my DMP Electronics XT30 keypad?
If the XMIT Green LED on your DMP Electronics Control Panel keypad is off, it could be due to the panel being reset. Remove the RESET jumper. Another reason could be that Flash Load is enabled. Remove the LOAD jumper and reset the panel.
What does it mean when the OVC LED turns red on my DMP Electronics XT30 Control Panel?
If the Overcurrent (OVC) LED on your DMP Electronics Control Panel turns red, it means too many devices are attached to the auxiliary. The maximum current draw allowed is 500 mA.
Why can't I arm/disarm my DMP Electronics XT30 Control Panel even though the keypad beeps?
If your DMP Electronics Control Panel keypad beeps when keys are pressed but doesn't allow you to arm/disarm or enter the User Menu, it's likely because two or more keypads have the same address. Ensure each keypad on the system has a unique address.
General| Brand | DMP Electronics |
|---|---|
| Model | XT30 |
| Category | Control Panel |
| Language | English |
To Next Page
