ParaMon-Pro X instruction manual DOC.60391-01/21
C. L/F Switch reverse
Able to set the Forward/Reverse switch settings inversely.
D. Forward RUN time limit (sec)
Limits forward operation time; an error occurs if exceeded.
E. Reverse RUN time limit (sec)
Limits reverse operation time; an error occurs if exceeded.
F. Motor Stall time limit (sec)
At reverse rotation, maximum hold time can be set in a stationary state.
The torque set in the Preset is applied equally for unscrewing as well as fastening.
For example, to unscrew the screws fastened with 10 kgf.cm, using 2 kgf.cm torque, the tool is unable to
unscrew the screws and gets into a stationary state. Then, maximum hold time can be set.
G. Loosening speed (rpm)
Able to set reverse rotation speed.
H. Acceleration (ms)
Able to adjust acceleration to reach target speed from the start of operation.
For more information, refer to ‘8.1 Fastening → Soft Start’.
I. Alarm reset time
Clears alarm automatically after the elapse of the preset time.
J. Torque calibration (%)
Depending on a vendor, there are various types of torque meters. Measurements can differ according to each
vendor’s implementation mechanism.
For example, when target torque is 10.00 kgf.cm, the torque meter can measure 9.5 kgf.cm.
In this case, it is required to select apparatus which can be the standard for torque management.
Once a tool is chosen for such torque management, no additional action is necessary.
If a torque meter is selected, on the contrary, it is able to calibrate the tool’s torque values by setting Torque
Calibration and ‘Fastening → Torque Compensation’.
Torque calibration can be set within ±10% and commonly applied to overall preset.
‘Fastening → Torque Compensation’ can be set within ±30% and applied to the preset only.
K. Initial torque preset
Able to set default preset values at tool reset.
The numbers 1-15 respond to the preset numbers.
The numbers 16-17 respond to multi-sequences ‘A’ and ‘B’ respectively.
L. LED / Light on time (sec)
If the trigger is executed, LED light is turned ON over the preset period of time.
To Next Page
Loading...
