ParaMon-Pro X instruction manual DOC.60391-01/21
A. Operation mode
Whether or not the Assembly Process Control, one of the major features of ParaMon-Pro X, would be enabled is
decided.
In ParaMon-Pro X, a single assembly process programmed by a user is called, ‘job’.
Depending on if the job is used, the mode is classified into ‘With job’ and ‘Without job’.
Uses the Process Control feature and runs
according to the procedures programmed in
the job.
Visualizes the complicated assembly
procedures of diverse products and targets to
minimize assembly errors.
Does not uses the process control feature;
able to use all tools randomly.
Usually used to save fastening data.
Operates the tools selected in the fastening
step only.
Locked for all other tool; unable to use
multiple tools simultaneously .
No restrictions on the use of tools.
Able to use all tools randomly at the same
time.
Able to register a code and set jobs.
The preset jobs are automatically loaded if
the registered code is scanned.
Able to register a code and presets when
the scanner-integrated BM is used.
Automatically converted into the preset if the
registered code is scanned.
To Next Page
