ParaMon-Pro X instruction manual DOC.60391-01/21
B. Screw count direction
Enabled under ‘With job’ mode only.
The screw count increases from ‘0’ to total count.
The screw count represents the number of fastened news.
The screw count decreases from total count to ‘0’.
The screw count refers to the number of remaining screws.
C. Screw count unit
Enabled under ‘With job’ mode only.
Displays the screw count in ‘Fastening step’ unit.
Displays screw count in ‘Job’ unit.
D. Job selection type via input
Enabled under ‘With job’ mode only.
Able to load up to 8 jobs through external input.
Handles job input (8 jobs in total), using the binary scale.
Job select 1 refers to the least significant bit (LSB) while Job select 8 represents
the most significant bit (MSB).
It ranges from 1 to 255, and the job for the Job No. is loaded.
Job select 1-8 is matched with job No. 1 in a one-to-one manner.
E. Barcode interface (only without job)
Enabled under ‘Without Job’ mode only.
In ParaMon-Pro X, the barcode scanner is divided into two different types depending on a connection
method.
Represents a scanner directly connected to ParaMon-Pro X through USB
Ignores ‘Remote Scanner’ if ‘Local Scanner’ is selected.
Refers to the scanner integrated with the BM.
Ignores ‘Local scanner’ if ‘Remote scanner’ is selected.
F. Automatically start default job on boot
Enabled under ‘With job’ mode only.
Able to set the system to make certain jobs executed automatically when ParaMon-ProX is reset.
To Next Page
