DOM Roq - Page 22

DOM Roq® Long Plate Outside / Round Rosettes Inside
22
DOM Roq® Smart Lock
4. Insert the key into the lock cylinder from the inside and then remove the forend screw
(fixing screw of the cylinder). (B)
5. Remove the existing (old) cylinder (C) by turning the key until the locking lug is in the
basic position (flush, 6 o'clock). You will notice that the locking lug is in the basic posi-
tion (flush, 6 o'clock) when you can pull out the cylinder with the key (see also Re-
moving the cylinder, page 12).
DOM Roq® Fig. 14: Long Plate Outside, Round Rose Inside
6. Insert new cylinder (with closing lug in basic position, page 13) from the inside. (D)
7. Insert the key from the outside (hold it in from the inside).
8. Check from the outside with the key whether the cylinder can operate the lock (no
grinding or sluggishness).
9. Drive out the latch with the help of the key.
10. Hand-tighten the cylinder with the forend screw. (E)
Attention! Damage due to braced installation.
Make sure that the locking lug does not rub against the side plate of the lock
and that the lock can be easily operated by the cylinder. Otherwise the cylinder
or the motor unit may be damaged.
11. Retract the latch and remove the key.
12. Check that the cylinder only protrudes a maximum of 4 mm.
13. Place the base plate on the cylinder. (F)
Note!
When mounting the base plate directly onto the door leaf, the cylinder may only
protrude a maximum of 4 mm from the door leaf. If the cylinder protrudes more
than 4 mm, please contact your DOM specialist dealer.