DOM Roq - Testing and Completion

DOM Roq® Completion and Testing After Mounting and Setup
56
DOM Roq® Smart Lock
Completion and Testing After Mounting and Setup
After completing the mounting and setup, perform the following tests to ensure that your
DOM Roq® motor unit is working properly.
1. Close the door (stay on the inside).
2. Lock the door manually from the inside using the rotary knob.
3. Unlock the door by pressing the push button once.
4. The motor unit unlocks the door.
5. Open the door.
6. Wait for approx. 3 seconds and press the push button.
7. The motor unit should not lock the door and should beep to indicate that the door is
not closed.
Note!
If the motor unit does not unlock the door or does not unlock it completely,
please repeat the steps from the end position setting.
If this is not successful either, please contact DOM support on our website or a
DOM specialist dealer.
Note!
If the motor unit locks the door, please repeat the steps for commissioning.
If this also does not lead to success, please contact DOM Support on our web-
site, or a specialist dealer.