DOM Roq® Commissioning
53
DOM Roq® Smart Lock
Setup DOM Roq® Motor Unit
Commissioning
1. Before operating the motor unit, you should fully charge the battery pack (see Charg-
ing the battery pack, page 62).
2. If necessary, remove the key on the outside.
3. Close the door and stay on the inside.
Attention!
The battery pack must always be inserted with the door closed to ensure proper
operation of the sensors.
4. Insert the charged battery pack and lock it.
5. When used for the first time, the LED flashes green slowly.
End Position Adjustment
6. Access the setting mode (see Commissioning) by pressing and holding the push but-
ton for 3 seconds (A) within the 30 seconds after inserting the battery pack. The LED
changes from slow green flashing to fast green flashing.
DOM Roq® Fig. 48: End Position Adjustment
Note!
After the battery pack has been inserted and latched, the setting mode is availa-
ble for 30 seconds (LED flashes green slowly).
To Next Page
Loading...
