DoorKing 80 Series Owner's Manual

1835-065-D-5-17
61
1. Press and enter your four-digit MASTER CODE (beep).
The LCD display will show the 10-digit phone number or system ID number.
?
? ? ? ?
6
MNO
MNO
5
JKL
JKL
6.1.7 Display DKS Data over IP Phone Number or System ID Number
This will allow you to see the DKS Data over IP issued 10-digit phone number or system ID number that has been programmed
into the telephone entry system.
1. Press and enter your four-digit MASTER CODE (beep).
The LCD display will show one of the following and the entry system will BEEP accordingly:
? ? ? ?
9
WXYZ
WXYZ
2
ABC
ABC
6.1.8 Test Connection to DKS Data over IP
This will allow you to test the connection to the DKS Data over IP or display problems that may have occurred.
System is Registered - (beep) one beep
- System is registered and communication to DKS Data over IP is good.
Check Registration - (beep-beep) two beeps
- Make sure your registration is current and this system is set to DKS Data over IP on the
registration screen. Also, be sure that the system phone number or ID number and the
master code are set the same on DKS Data over IP and the entry system.
Program 10 Digit ID - (beep-beep-beep) three beeps
- There is not a valid 10-digit ID in the entry system memory. (see section 3.2.10)
Turn DKS Data over IP On - (beep-beep-beep-beep) four beeps
- There is a valid 10-digit ID, but DKS Data over IP is turned OFF. (see section 6.1.9 below)
No DKS Data over IP Contact - (beep-beep-beep-beep-beep) five beeps
- Communication to DKS Data over IP could not be made.
Note: The display will show C's (C C C C C C C C C C) if a phone number or system ID has NOT been programmed.
Use the following sequence to turn DKS Data over IP OFF or ON.
If you are going to use the RS232 connection for any other RS232 functions other than DKS Data over IP (e.g., connecting a PC
directly to the phone entry system via the RS232 terminal), the DKS Data over IP must be turned OFF.
The DKS Data over IP must be ON to use the entry system with DKS Data over IP. Note: When section 3.2.10 (DKS Data over
IP Phone Number or System ID Number is programmed, the DKS Data over IP is automatically turned ON.
If there is NOT a valid 10 digit system phone number or system ID number in memory, the system will emit three (3) short
beeps. Beep ... Beep ... Beep
6.1.9 Turn DKS Data over IP OFF or ON
1. Press and enter your four-digit MASTER CODE (beep).
2. Press (beep) to turn OFF, OR (beep) to turn ON.
3. Press together to end this programming sequence (beeeeeep).
? ? ? ?
5
JKL
JKL
5
JKL
JKL
0
OPER
OPER
1
SP
SP
0
OPER
OPER
N Yhlh iDKS D IP dl bl
Note: If there is pending data to be transfered when this test is performed, the data transfer will occur.

DoorKing 80 Series Specifications

General

Brand	DoorKing
Model	80 Series
Category	Intercom System
Language	English