Operation Section
-93-
Sideshift Attachment Control
The side shift attachment controller is at the front-
right side of the driver, and the side shift control lever
is at the right as shown in the figure.
1. Side Shift Left – open the knob softly
forward to move the carriage to the left.
2. Side Shift Stop – release the side shift
knob. The knob will return to HOLD
position and the side shifting operation will
stop.
3. Side Shift Right – pull the knob softly
forward reverse to move the carriage to the
right.
NOTE: To prevent sudden position shift of the load,
operate the lift, tilting and side shift controller
smoothly.
Emergency Switch
OFF - Push the emergency switch button to
disconnect the electrical circuits. (It must be
done after the key switch is turned off)
ON - Pull the emergency switch button to
connect the electrical circuit.
When the vehicle is in forward or reverse, turning on
the emergency switch disables the forward/reverse
switch. To have it enabled, turn the emergency
switch off and set the forward/reverse switch in
neutral before driving the vehicle.
To Next Page
Loading...
