6.2.8 Deactivating OD and CW (P2)
To deactivate the Opening Delay (OD) and Confirmation Window (CW), enter twice "00" to
define the time for OD/CW. After the deactivation of OD/CW all operators can open the lock
without delay.
1. Press P.
2. Enter the valid Master Code 00XXXXXX.
00 = ID; X = valid 6-digit combination for the Master Code
3. Press the ENTER key.
ð The green light blinks twice and stays on, the acoustic signal sounds twice.
4. Press P2.
5. Press the ENTER key.
ð The green light stays on and the acoustic signal sounds twice.
6. Enter 0000.
7. Press the ENTER key.
ð The green light turns off and the acoustic signal sounds twice.
6.2.9 Activating Dual Mode (P7)
Keep in mind that for the activation of the Dual Mode at least 2 operators with valid codes
are necessary. Otherwise, an error message is displayed during the activation of the Dual
Mode.
It is possible to configure the lock in such a way that 2 activated, but different codes
(different IDs) are required for lock opening e.g. the Master Code and any other second code
or any 2 other codes. The Dual Mode includes all operators (Master Code, User Codes and the
Courier Code). The Dual Mode must be deactivated before to be able to be activated.
1. Press P.
2. Enter the valid Master Code 00XXXXXX.
00 = ID; X = valid 6-digit combination for the Master Code
3. Press the ENTER key.
ð The green light blinks twice and stays on, the acoustic signal sounds twice.
4. Press P7.
5. Press the ENTER key.
ð The green light turns off and the acoustic signal sounds twice.
If the red light blinks twice and the acoustic signal sounds twice, Dual Mode has been
deactivated before. All steps must be repeated to activated Dual Mode.
OperationUser Manual
19- 02/2022 dormakaba Combi B 90 with metal input unit
To Next Page
Loading...
