6.3.2 Creating User Codes or the Courier Code (P3)
Codes must be activated before being used. The new code must be tested by opening the lock.
For correct use of the lock, the Manager Code must be activated.
When activating a new operator, make sure that the new code is entered directly by the
respective operator on site. If the new code is not entered by the respective operator, but the
new code is assigned by the manager, the respective code must be replaced as soon as
possible by the real personal code from the respective operator.
1. Press P.
2. Enter the valid Manager Code 01XXXXXX.
01 = ID; X = valid 6-digit combination for the manager
3. Press the ENTER key.
ð The green light blinks twice and stays on, the acoustic signal sounds twice.
4. Press P3.
5. Press the ENTER key.
ð The green light is on and the acoustic signal sounds twice.
6. Enter a new code ID XXXXXX.
01 = ID; Y = newly configured 6-digit combination
7. Press the ENTER key.
ð The green light is on and the acoustic signal sounds twice.
8. Confirm the new code with ID XXXXXX.
ð The green light turns off and the acoustic signal sounds twice.
If both entered codes do not match, the red light blinks 3 times and the acoustic signal sounds
3 times after the second code entry when the code confirmation is wrong.
If the red light blinks 3 times and the acoustic signal sounds 3 times after the first code entry,
the code is already active.
6.3.3 Disabling User Codes or the Courier Code (P4)
After a code is disabled, it is not possible to use the code until the code will be enabled.
1. Press P.
2. Enter the valid Manager Code 01XXXXXX.
01 = ID; X = valid 6-digit combination for the manager
3. Press the ENTER key.
ð The green light is on and the acoustic signal sounds twice.
4. Press P4.
5. Press the ENTER key.
ð The green light blinks twice and stays on, the acoustic signal sounds twice.
OperationUser Manual
23- 02/2022 dormakaba Combi B 90 with metal input unit
To Next Page
Loading...
