Dover HEIL Half/Pack Factor AFL - Page 133

Half/Pack
®
Issued April 2018
Body Controller Software
Copyright 2018, Heil Environmental
Printed in the U.S.A.
Body Controller Software
127
I02 Input Function -- Packer Extend Input (CAN - In Cab Input)
This CAN control is used to turn ON/OFF the Packer Extend control either from Street side or from the
Curb side of a dual control panel unit.
Condition
Modifiable Parameters
Default Setting
A
None
N/A
Function Logic:
Input Device
Status
I/O Address
Status
Packer Extend Input
Activated
CAN
ON (CAN Control)
I03 Input Function -- Packer Retract Input (CAN - In Cab Input)
This CAN control is used to turn ON/OFF the Packer Retract control either from Street side or from the
Curb side of a dual control panel unit.
Condition
Modifiable Parameters
Default Setting
A
None
N/A
Function Logic:
Input Device
Status
I/O Address
Status
Packer Retract Input
Activated
CAN
ON (CAN Control)
I04 Input Function -- Packer Over-height Override Switch Circuit (CAN - In Cab Input)
This CAN control is used to turn ON/OFF the Packer Over-height Override control either from Street side or from the Curb
side of a dual control panel unit. This switch is for future expansion if needed, and currently interrupts a pack cycle in
progress.
Condition
Modifiable Parameters
Default Setting
A
None
N/A
Function Logic:
Input Device
Status
I/O Address
Status
Packer Over-height Override Input
Activated
CAN
ON (CAN Control)
I05 Input Function – Select-O-Pack Switch Circuit (CAN - In Cab Input)
This CAN control is used to turn ON/OFF the Select-O-Pack control either from Street side or from the Curb side of a dual
control panel unit. This circuit monitors the ON/OFF status of the Select-O-Pack Switch. This circuit enables Auto Pack
and Auto Retract action.
Condition
Modifiable Parameters
Default Setting
A
None
N/A