Dover HEIL Half/Pack Factor AFL - Page 138

Half/Pack
®
Issued April 2018
Body Controller Software
Copyright 2018, Heil Environmental
Printed in the U.S.A.
Body Controller Software
132
Input Device
Status
I/O Address
Status
Auto lift Mode Button
Activated
CAN
ON (CAN Control)
J08 Input Function – Joystick – Operator presence (CAN – Cab Input)
Joystick operator presence input is a capacitive sensor embedded in the Multi-function joysticks that is activated when the
operators hand is placed around the joystick handle.
Condition
Modifiable Parameters
Default Setting
A
None
N/A
Function Logic:
Input Device
Status
I/O Address
Status
Joystick Operator Presence
Activated
CAN
ON (CAN Control)
4.12: OPTION CAN Auxiliary-Cab Input Functions
K01 Input Function – Auxiliary Arms/Forks Control Enable Switch (CAN - In Cab Input)
This is used to turn ON the - Auxiliary Arms/Forks control Enable switch that Enables or Disables the
control for operating the Auxiliary Arms/Forks control.
Condition
Modifiable Parameters
Default Setting
A
None
N/A
Function Logic:
Input Device
Status
I/O Address
Status
Auxiliary Arms/Forks Control Enable
Activated
CAN
ON (CAN Control)
K02 Input Function – Auxiliary Arms Raise Switch (CAN - In Cab Input)
This Auxiliary CAN control is used to turn ON the - Arms Raise switch using Auxiliary control. This input is operative only if
Auxiliary Controls Enable Switch is ON (Refer K01).
Condition
Modifiable Parameters
Default Setting
A
None
N/A
Function Logic:
Input Device
Status
I/O Address
Status
Auxiliary Arms Raise
Activated
CAN
ON (CAN Control)
K03 Input Function – Auxiliary Arms Lower Switch (CAN - In Cab Input)
This Auxiliary CAN control is used to turn ON the - Arms Lower switch using Auxiliary control. This input is
operative only if Auxiliary Controls Enable Switch is ON (Refer K01).