Dover HEIL Half/Pack Factor AFL - Page 141

Half/Pack
®
Issued April 2018
Body Controller Software
Copyright 2018, Heil Environmental
Printed in the U.S.A.
Body Controller Software
135
Auxiliary Curotto (Release) Switch
Activated
CAN
ON (CAN Control)
K11 Input Function – Auxiliary Curotto (DUMP) Switch (CAN - In Cab Input)
Here the Auxiliary Curotto control (DUMP) switch performs the Curotto Can Dump. This input will be
active only if Auxiliary Curotto Control Enable Switch is ON (Refer K08).
Condition
Modifiable Parameters
Default Setting
A
None
N/A
Function Logic:
Input Device
Status
I/O Address
Status
Auxiliary Curotto (Dump) Switch
Activated
CAN
ON (CAN Control)
K12 Input Function – Auxiliary Curotto (UNDUMP) Switch (CAN - In Cab Input)
Here the Auxiliary Curotto control (UNDUMP) switch performs the Curotto Can Undump. This input will be active only if
Auxiliary Curotto Control Enable Switch is ON (Refer K08).
Condition
Modifiable Parameters
Default Setting
A
None
N/A
Function Logic:
Input Device
Status
I/O Address
Status
Auxiliary Curotto (Undump) Switch
Activated
CAN
ON (CAN Control)
K13 Input Function – Auxiliary Curotto (IN) Switch (CAN - In Cab Input)
Here the Auxiliary Curotto control (IN) switch makes the Curotto Can Arm retract. This input will be
active only if Auxiliary Curotto Control Enable Switch is ON (Refer K08).
Condition
Modifiable Parameters
Default Setting
A
None
N/A
Function Logic:
Input Device
Status
I/O Address
Status
Auxiliary Curotto (IN) Switch
Activated
CAN
ON (CAN Control)
K14 Input Function – Auxiliary Curotto (OUT) Switch (CAN - In Cab Input)
Here the Auxiliary Curotto control (OUT) switch makes the Curotto Can Arm extend. This input will
be active only if Auxiliary Curotto Control Enable Switch is ON (Refer K08).
Condition
Modifiable Parameters
Default Setting
A
None
N/A