Half/Pack
®
Issued April 2018
Body Controller Software
Copyright 2018, Heil Environmental
Printed in the U.S.A.
Body Controller Software
152
C. Top Door Configuration bit is ON.
D. Cab Protector Down Configuration bit is ON.
Disabled Functions: Forks will not be Lowered.
Fault Reset: Open the top door fully. Check top door, Cab protector down prox., Lift below Transit prox.,
Forks position and Arms position for proper operation.
Cab Protector Down with Forks Untuck and Arms Lowered Docked Interlock (standard
equipment)
The arms have been lowered when the top door is not fully open and Forks Untuck position is ‘113’ and Arm Angle
position is lesser than ‘110’, the diagnostic message will be displayed in the Insight display.
Insight Display Illustration: BEEP CODE 19-2
Indication: A. Top Door Open light ON.
B. Residential Configuration bit is ON.
C. Top Door Configuration bit is ON.
D. Cab Protector Down Configuration bit is ON.
Disabled Functions: Forks will not be Lowered.
Fault Reset: Open the top door fully. Check top door, Cab protector down prox., Lift below Transit prox., Forks position
and Arms position for proper operation.
Top Door Open and Arms Lowered Interlock (standard equipment)
If arms have been lowered when the top door is not fully open or the Arm position angle is greater than the Fork roll
position value (700) and the Fork position is greater than Feather Up range (610) and the Top door configuration bit is
ON and Residential configuration bit is ON, the diagnostic message will be displayed in the Insight display.
Insight Display Illustration:
To Next Page
Loading...