6.3.7 Leak Test
The console can run a leak test in 3 ways:
l Automatic test: In this mode, the user can program the test frequency and the console will
automatically try to run a test at the specified frequency.
l Scheduled test: The user can program the test to start at a specified date and time.
l On demand: The user can select to start the test now.
On a web browser, the user can configure the automatic and scheduled leak test. The On-demand test can
be started through the web browser Tank Status menu or through the Graphical User Interface.
The console will start the test if the applicable parameters are correct (i.e a stable level in the tank and 8 hrs
after the last fuel delivery). Activity in the tank such as a pump sale or a fuel delivery will automatically abort
the test.
The algorithm compares the temperature compensated volume between the start and end of the test period.
External factors can affect the test results (such as ground vibration, extreme winds that cause too much
evaporation, probe failure or a sticky float, incorrect tank charts).
M2051_r4 MagLink LX 4 and LX Plus Configuration Manual | Dover Fueling Solutions 45
To Next Page
Loading...
