Section 2 General Warnings
Carefully read the instructions in this manual before you do the installation procedures.
Only approved persons are permitted to install this equipment and configure the console.
The manufacturer is not responsible for operations that are not included in this manual.
The manufacturer is not liable in regard to competent bodies for changes to the equipment and software that
are not approved.
In case of failure or defect, refer directly to an authorized service provider or manufacturer.
The manufacturer is not liable for injury and/or damage to persons and/or property and/or pets caused by the
failure to obey safety instructions.
All approved personnel must know all safety requirements in this manual, the configuration manual and the
user manual.
Refer directly to an approved service provider or manufacturer for questions about the operation of the
equipment.
IMPORTANT: You must read and obey all safety instructions in this manual before you use
this equipment.
WARNING: Incorrect use of this equipment that does not agree with the
instructions in this manual can cause a risk to safety.
WARNING: A minimum insulation thickness of 0.25 mm is necessary for all
internal wiring of different intrinsically safe circuits.
A grounding conductor must be connected between the I.S. ground terminals
of the Intrinsic safety barrier in the console and the power distribution panel.
This connection must have a cross-sectional area of at least 4 mm2 for the
added earth connection.
WARNING: Substitution of components can decrease intrinsic safety.
ADVESTISEMENT: La substitution des composants peut compromettre la
sécurité intrinsèque
M2051_r4 MagLink LX 4 and LX Plus Configuration Manual | Dover Fueling Solutions 8
To Next Page
Loading...
