2016-11 17 / 58
-6-
6.3.f - PULIZIA FILTRO ARIA CABINA
Il fi ltro è posizionato sul lato sinistro del tunnel plancia co-
mandi e serve per fi ltrare l’aria che entra in cabina.
Per la pulizia, agire come segue:
- Rimuovere il pannello (1) previa rimozione delle relative
viti di fi ssaggio.
- Rimuovere i fi ssaggi (2) della cornice di ritegno.
- Estrarre il fi ltro (3) e pulirlo utilizzando un getto di aria
compressa in leggera pressione.
- Se il fi ltro si presenta molto intasato o lesionato deve
essere sostituito.
- Riposizionare il fi ltro nella sede, installare la cornice di
ritegno e rimontare il pannello (1).
2 2
3
1
6.3.f - CAB AIR FILTER CLEANING
The fi lter is located on the left side of the dashboard tunnel
and serves to fi lter the air entering the cab.
In order to clean it comply with the following procedure:
- Remove the fastening screws of the panel (1), then the
panel itself.
- Remove the fasteners (2) of the retaining frame.
- Extract the fi lter (3) and clean it with a jet of compressed
air under slight pressure.
- If the fi lter is very clogged or damaged must be replaced.
- Put the fi lter back in its housing, install the retaining
frame and replace the panel (1).