23
6. OPERATING PROCEDURES
11 Decide the speed.
When using the jogger unit and paper
receiving table
• When the power is turned on, the speed will be set to
“Slow” (35 sets/minute). ....SLOW lamp lights up
• To set to “Fast” (55 sets/minute), press the
SPEED key. ............................ Fast lamp light up
When pressed again, the speed will be set to “Slow”
again.
Note
If an error occurs with the speed set to “Fast”, there
will be more sets of damaged paper.
When using peripherals
• The speed of these devices differs according to the
model used.
The FAST or SLOW lamp shows the speed
according to the peripherals. Refer to the
downstream processing device.
12 Press the PRESET key.
• The paper on the paper feed table will be fed for
only one set.
The NO. OF SETS window will display 1.
Refer to “6-2. Preset Key” on page 26.
Check one set of paper ejected to the paper receiving
table or downstream processing device.
• If paper feed errors occur, check the cause and
correct it.
Refer to “7. WHAT TO DO WHEN...” on page 31.
• After correcting the error, press the CLEAR key
and return the counter to 0, and then press the
PRESET key again.
To Next Page
Loading...
Need help?
General
